|
|
The Fly has infinitely adjustable softness (give), and adjustable stroke, controlled by a screw on the top of the machine.
For harder hitting (lining or color packing), turn the control screw clockwise. For softer hitting (shading), turn the control screw counterclockwise.
This machine is capable of hitting very softly compared to the best conventional coil shading machines.
The control screw for the softness (give) on the Fly is on the top side and inside of the machine, and is therefore protected in case the machine hits the floor.
Each Fly machine comes with a wrench adjuster that customizes the control screw for softness (give).
Soft or hard hitting all with the same machine!
This machine can be adjusted on the fly you only need 5 seconds to turn it from a liner to a shader without the need of touching the power supply.
The latest version of the Fly has a new precision adjustable needlebar stabilizing system which allows us to operate the machine without rubberbands, just add the exact amount of pressure against the needlebar and get a perfect stabilazed needle.
Improved tube vice locking system for the grips.
The Fly is the only rotary tattoo machine on the market that can be autoclaved.
Easy to plug/unplug the motor-engine from one Fly machine into or out of other Fly machines with different needle configurations thanks to Stigma-Rotary’s® new “easyplug” system.
You only need one motor-engine to run multiple Fly machines.
The Fly can be set up to hit at short, medium, or long strokes by simply changing the interchangeable excenters on the motor- engine. It is capable of hitting at any stroke length from 2,6 mm up to 5,5 mm to suit your needs, for maximum efficiency and for the shortest healing times.
The Fly weighs only 73 grams (2.5 oz). Ergonomic design and well balanced.
The motor-engine for the Fly weighs only 57 grams (2oz).
The Fly, together with the motor-engine, weighs only 130grams (4.5 oz).
The motor-engine carries a powerful 4,5 watt motor (Swiss-made) by Maxon motor.
Drives up to 50 needles or more without problems.
The motor-engine for the Fly carries the excenter with a bearing. it is a medium stroke excenter which causes minimum 3,5 mm stroke and maximum 4,4 mm stroke.
The motor engine for the Fly always comes with a medium stroke excenter which causes minimum 3,5 mm stroke and maximum 4,4 mm stroke.
Optionally, we offer shorter and longer stroke excenters, the short stroke version causes minimum 2,6 mm stroke and maximum 3,4 mm stroke.
The long stroke version causes minimum 4,4 mm stroke and maximum 5,5 mm stroke.
The Fly is perfectly CNC-machined from a solid block of aircraft aluminum and then anodized.
Patented machine copying or duplicating is not allowed.
Designed for use with standard needles, tubes, grips, and power supplies.
Linear armature motion.
Adjust the speed by the power supply to 3.000 ~ 10.000 stitches per minute.
7-13 volt.
Low vibration, low noise, easy handling and flexibility, no tuning, no trouble.
RCA jack and clipcord connections are both on the machine.
The Fly are infinitely adjustable (no grades) for “give” and stroke rotary machines better than coil machines.
|
